![set an ip address on a qj71e using gx works 2 set an ip address on a qj71e using gx works 2](https://www.mymitsubishisupport.co.za/wp-content/uploads/2021/04/6.png)
- #Set an ip address on a qj71e using gx works 2 update#
- #Set an ip address on a qj71e using gx works 2 series#
| eth3|-|IPSec tunnel|-|GigabitEthernet0/8/0 |
#Set an ip address on a qj71e using gx works 2 series#
This section covers using manually-keyed IPSec connections between VPP and native IPSec stack in the 2.6 kernel series (Ubuntu 14.04) in ESP transport mode.
#Set an ip address on a qj71e using gx works 2 update#
The following example command shows the configuration sequence to update a Security Association (SA) keys: Priority 10 action protect protocol any sa 20 Remote addr rangeĀ :: - ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff port range 0 - 65535 Local addr rangeĀ :: - ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff port range 0 - 65535 Priority 10 action protect protocol any sa 10 Priority 100 action bypass protocol IPSEC_ESP The following example commands show the configuration sequence to create a SPD entry:
![set an ip address on a qj71e using gx works 2 set an ip address on a qj71e using gx works 2](https://www.proface.com/library/SCHNEIDER_ELECTRIC/SE_LOCAL/PROFACE/FA60876/q_ether.png)
![set an ip address on a qj71e using gx works 2 set an ip address on a qj71e using gx works 2](http://www.semitronix.com/uploads/image/20180725/1532521568.jpg)
2.3.1.2 strongSwan initiator configuration.2.3.1 IKEv2 negotiation between a VPP responder and a strongSwan initiator, using Pre-Shared Key authentication method.1.4.1 IPSec between VPP peers, tunneling IPv4 over IPv6.